Technical Description

Allows control of up to 200 24V 0.3W LED lamps.
Data input via RS232 from PC or notebook.
DMX 512 input from PC or lighting desk.
Built in removable memory card system for storing control sequences.
Any number of power supplies can be synchronized by utilising a basic master slave system via a 2 core cable.
Protection from lamp wiring faults.
Very strong IP66 plastic enclosure with cable glands.
Low maintenance unit with easily replaceable PCB assembly.
Fully remote start-stop control facility available.
110 / 230VAC input.
Fully self diagnostic unit with fault indication system including
Internal fuse failure
Output short circuit
Memory card active download
DMX sync received
Driver failure

CE and UL Approved

MEMORY CARD
The memory card holds all the user programmes for lamp sequence control. Up to 30,000 scenes can be stored on a single memory card, each card is easily programmed via any PC or laptop, each memory card can be easily removed and re-fitted as and when required

LAMP UNIT
Each lamp holder unit controls a single 0.3W BC lamp, the lamp units are designed to withstand very harsh environments and operate equally well in both indoor and outdoor applications.
The lamp units are connected onto a common cable by piercing the cable insulation with two fine pins, this process causes minimal damage to the cable and allows quick and simple installation with the pins forming a weatherproof seal around the cable.
A surface mounting clip is also available, this clip can also be reversed to enable through panel mounting for signage applications etc.

Technical Description

IP67 rating tested for long term environmental protection.
Includes lamp filament pre heater system to extend bulb life by 3-5 times.
Lamp unit drives 0.3W 24V LED lamp.
Fast, easy connection/disconnection from festoon cable with no special tools required.
Protected against lamp contacts short circuit.
Each lamp can be easily programmed and re-programmed with its own unique address using the Cybertec hand held controller detailed below.
Each lamp excepts four commands.
lamp on
lamp off
lamp fade up (fade time 0.1 - 180 seconds)
lamp fade down (fade time 0.1 - 180 seconds)
Easy to fit surface mount or through panel mounting clip

SOFTWARE
The Cybertec DF software is a very easy to use graphical system developed to make custom lighting displays very simple to programme, an unlimited number of lamps can be viewed and arranged in any pattern on screen at any one time, this pattern forms a layout file which can be saved, once this layout is completed to your satisfaction the state of each lamp can be set to form a scene, the scene duration and fade time for the scene can also be programmed. Scene durations of 0.05 seconds to 50 minutes are available, the fade time range is 0.1 to 180 seconds, using this system up to 30,000 scenes can be created.

Each lamp has four states

Lamp on
Lamp off
Lamp fade up (fade time 0.1 - 180 seconds)
Lamp fade down (fade time 0.1 -180 seconds)

In addition to the above lamp states each scene also has a programmable duration, this duration simply defines how long each scene lasts (how quickly and how often a lamp turns on and off and how quickly a lamp fades up or down, and to what brightness.

HAND HELD PROGRAMMER
This handy little programmer is an optional feature aimed at mid to high volume users, the hand held programmer connects to the lamp holder in place of the lamp, once inserted the programmer can reprogram the lamp units address and can also verify that the unit is operating correctly.